Step #1

Clean the Mirror Housing thoroughly (tar and grease remover is recommended).

Step #2

Position the 3/8” elastic-bound opening of the Mirror Cover at the outside end of the mirror housing and applying equal pressure slide over the mirror housing. Note: this is a tight fit but the material will stretch to allow the cover to pass over the housing. Position the cover so the 1/4” elastic-bound opening is over the mirror glass.

Step #3

Using the flat edge of a plastic card, such as a credit card or driver’s license, wedge the material thru the gap between the mirror glass and the mirror housing. Note: You may need to adjust the mirror glass manually to create a gap to get started.

Step #4

Arrange the material by adjusting as necessary to position the cover smoothly over the housing.

Note: the neck of the mirror cover may be positioned towards the base of the housing or it may be tucked into the neck of the housing by turning the housing and then returning to its original position.

Note: it may be necessary to use the card edge when removing the mirror cover if the material hangs up on the retaining clips inside the housing